ALPS Manufacturer of Electronic Components/Parts Catalog

Low-profile One-way Operation Type SPVP Series


Part number SPVP110100

Poles 1
Positions 1
Terminal type For PC board (Reflow)
Operating force 0.55N max.
Location lug With
Minimum order unit (pcs.) 18,000

Operating temperature range -40℃ to +85℃
Rating (max.)/(min.) (Resistive load) 1mA 5V DC/100μA 3V DC
Electrical performance Contact resistance (Initial performance/After lifetime) 5Ω max./10Ω max.
Insulation resistance 100MΩ min. 100V DC
Voltage proof 100V AC for 1 minute
Mechanical performance Terminal strength 0.5N for 1 minute
Actuator strength 5N
Vibration 10 to 55 to 10Hz/min., the amplitude is 1.5mm for all the frequencies, in the 3 direction of X, Y and Z for 2 hours respectively
Resistance to soldering heat Manual soldering 350±5℃, 3s max.
Reflow soldering Refer to soldering conditions
Durability Operating life without load 50,000 cycles 10Ω max.
Operating life with load (Load: as ratings) 50,000 cycles 10Ω max. (1mA 5V DC)
Environmental performance Cold -40±2℃ for 500h
Dry heat 85±2℃ for 500h
Damp heat 60±2℃, 90 to 95%RH for 500h

Certificate of Compliance to RoHS regulations  


Detector Switch

Mounting Hole Dimensions

Detector Switch

Viewed from direction A in the dimensions.

Terminal Layout

Detector Switch

Circuit Diagram

Detector Switch

Packing Specifications


Number of packages (pcs.) 1 reel 4,500
1 case / Japan 9,000
1 case / export packing 18,000
Tape width (mm) 16
Export package measurements (mm) 417×409×139

Soldering Conditions

Example of Reflow Soldering Condition
1. Heating method :
Double heating method with infrared heater.
2. Temperature measurement :
Thermocouple 0.1 to 0.2 Φ CA (K) or CC (T) at soldering portion (copper foil surface). A heat resisting tape should be used for fixed measurement.
3. Temperature profile
(1) The condition mentioned above is the temperature on the mounting surface of a PC board. There are cases where the PC board's temperature greatly differs from that of the switch, depending on the PC board's material, size, thickness, etc. The above-stated conditions shall also apply to switch surface temperatures.
(2) Soldering conditions differ depending on reflow soldering machines. Prior verification of soldering condition is highly recommended.
3s max.

Notes are common to this series/models.
  • This site catalog shows only outline specifications. When using the products, please obtain formal specifications for supply.
  • Please place purchase orders per minimum order unit (integer).
  • This products can be used in vehicles.
    Although these products are designed to perform over a wide operating temperature range, please ensure that you receive and read the formal delivery specifications before use.
Inquiries about Products
For more information please contact: Products Information Center.
1-7, Yukigaya-otsukamachi, Ota-ku, Tokyo, 145-8501, Japan
Phone: +81 (3) 5499-8154